Cleanroom Equipment

Air filters

Washable mesh-panel coarse filters in stainless steel, nylon and aluminium for the first filtration stage of air handling units, holding back large dust before finer stages.

Fan filter units and controls

Ceiling fan filter units with conventional AC motors for cleanroom builders who need a lower-cost unit where individual or small-group speed control is enough and filters are replaced during routine maintenance.

Air filters

First-stage panel and pocket pre-filters in synthetic fibre, washable and high-temperature constructions, for air handling units serving commercial and industrial buildings.

Biopharma and laboratory equipment

Vaporized hydrogen peroxide equipment in three unit types: fumigation pass boxes for small items, decontamination transfer rooms for large loads, and generators that supply sterilant gas to isolators, pass boxes and small rooms.

Air filters

Bag and rigid-case medium-efficiency filters (F5–F9 to EN 779) in synthetic fibre, glass fibre, panel and box constructions, for the middle stage of air handling systems.

Biopharma and laboratory equipment

Pass boxes that disinfect items with intense pulsed xenon ultraviolet light while transferring them between clean and non-clean areas, reaching a high kill rate within minutes instead of the roughly 30 minutes a conventional UV pass box needs.

Fan filter units and controls

Ceiling blower filter units with a built-in fan for turbulent and laminar cleanrooms, bought by cleanroom builders who want a self-contained unit that filters and pushes air into the room without a remote air handling unit.

Air filters

High-medium-efficiency filters with very low initial resistance for ventilation systems with little spare fan pressure, such as hospital diagnostic and treatment rooms.

Fan filter units and controls

Ultra-thin fan filter units about half the depth of a standard FFU for equipment-end local filtration in clean plants, bought where ceiling or equipment void space is limited and chemical outgassing must stay low.

Air filters

Close-pleated sub-HEPA (EPA) panel filters on ultra-fine glass fibre or polypropylene paper, rated 95 % to 99.95 %, for cleanrooms and areas between medium and HEPA stages.

Biopharma and laboratory equipment

Gas-tight pass boxes with mechanically compressed doors, electromagnetic interlock and optional glove port, used where samples must move between zones without any leakage of hazardous agents.

Air filters

W-shaped high-airflow sub-HEPA filters for central air conditioning and central ventilation systems, removing 1–5 µm particles at high airflow and low resistance.

Biopharma and laboratory equipment

Pass-through chambers with a disinfectant basin, used in high-containment laboratories to move small acid- and alkali-resistant items through a liquid disinfection barrier between two rooms.

Fan filter units and controls

Fan filter units with a gel-seal filter fixing for high-grade cleanrooms, bought where the seal between filter and casing must block contamination reliably and where single units or bands of units sit above process points.

Air filters

Separatorless mini-pleat HEPA panels of ultra-fine glass fibre paper with hot-melt pleat spacing, for terminal filtration in electronics, pharmaceutical and hospital cleanrooms.

Air filters

HEPA panel filters with aluminium foil separators between pleats of ultra-fine glass fibre paper, for terminal filtration where a rigid, corrosion-resistant pack is needed.

Fan filter units and controls

Fan filter units in an explosion-proof construction for cleanrooms where flammable solvents, vapours or dusts are handled, bought by pharmaceutical, electronics and food plants that must keep air filtration running in a classified hazardous area.

Air filters

Separator-style HEPA panels with paperboard separators and polyurethane sealant in galvanised, stainless or aluminium frames, for terminal filtration in cleanrooms.

Fan filter units and controls

Self-contained fan filter units for spot supply of filtered air in clean zones, bought to add a local clean-air point quickly or to back up an existing ceiling system in semiconductor, electronics, laboratory and hospital areas.

Fan filter units and controls

Central control systems that manage a ceiling of EC fan filter units from one point, bought with EC FFU projects in semiconductor, pharmaceutical and large cleanroom buildings where speed, monitoring and energy use must be managed together.

Biopharma and laboratory equipment

HEPA supply air outlets with a gel-seal channel that locks the filter frame against the housing knife edge for a leak-tight seal, in top-feed and side-feed versions with an optional regulating damper.

Air filters

HEPA and ULPA panels on PTFE membrane media for corrosive, high-temperature or copper-and-zinc-free duties where glass fibre paper is not suitable.

Cleanroom equipment

Personnel air showers with HEPA-filtered air jetted from nozzles on two sides, used at cleanroom entrances to remove dust from clothing before entry; the buyer's contractor positions and connects the cabin on site.

Fan filter units and controls

Central control systems that manage a ceiling of AC fan filter units from one point, bought with AC FFU projects in semiconductor, pharmaceutical and large cleanroom buildings where many units must run and be monitored together.

Cleanroom equipment

Personnel air showers that add top nozzles to the two side walls so filtered air blows from three directions, for entries where a more thorough dust removal is required; installed and connected by the buyer's contractor.

Biopharma and laboratory equipment

Negative-pressure booths for weighing powder materials: a fan pulls air through primary, medium-efficiency and HEPA stages over the work zone, containing the powder and protecting the operator and the room.

Fan filter units and controls

Modular aluminium ceiling grid systems that carry FFUs, blank panels, lights and duct ends in a cleanroom ceiling, bought by cleanroom builders who want a demountable, reusable grid that can be cut on site and reconfigured later.

Air filters

HEPA panels with an integral knife-edge frame that pushes into a gel-filled sealing channel, for terminal positions where a gasket seal cannot guarantee tightness.

Fan filter units and controls

Close-out panels that seal unused FFU positions in a cleanroom ceiling grid, bought with FFU ceilings to keep unfiltered air out of the room, keep airflow even across the grid and leave a flat, cleanable ceiling plane.

Air filters

Mini-pleat HEPA panels with a gel potting groove around the flange, sealing against a knife-edge frame for terminal positions in industrial and biological cleanrooms.

Biopharma and laboratory equipment

Rigid or flexible containment isolators that separate the work zone from the room with a physical barrier and controlled airflow: aseptic units for sterile operations, cell therapy units with integrated equipment, and negative-pressure units for potent or infectious products.

Air filters

Box-type HEPA filters with mini-pleat packs arranged in a V formation, giving high airflow capacity and low structural resistance in air handling units.

Air filters

HEPA panels rated for continuous service at 250–280 °C or up to 400 °C, with stainless frames, aluminium foil separators and high-temperature sealant for ovens and hot process air.

Biopharma and laboratory equipment

Mobile vertical-laminar-flow units (sampling carts) that bring a local HEPA-filtered clean zone to the sampling or transfer point for raw and auxiliary materials in pharmaceutical production.

Air filters

Panel, box and W-type activated carbon filters that remove odours and gaseous contaminants by adsorption, for make-up air and recirculation in industrial ventilation.

Biopharma and laboratory equipment

Low-leakage airtight dampers for ventilation ducts in containment facilities, closing with a gas-tight seal so rooms can be isolated for decontamination and zero-leakage duty at a specified pressure difference.

Cleanroom equipment

Cargo air showers with rapid roll-up doors for high-frequency goods transfer into cleanrooms; door speed, curtain colour and control mode are fixed per configuration, and the buyer's contractor handles positioning and power on site.

Air filters

Panel, box and FFU chemical filters with adsorbent media for removing specific gaseous contaminants from process air, cleanrooms and fan filter units.

Biopharma and laboratory equipment

Mist showers that remove active or toxic dust adhered to cleanroom garments with a fine water mist before personnel leave a controlled area, installed between clean and non-clean zones.

Cleanroom equipment

Cargo air showers with automatic sliding doors for logistics corridors serving semiconductor, pharmaceutical and food plants; door sensing and the shower cycle are automatic, and the buyer's contractor positions and connects the unit on site.

Biopharma and laboratory equipment

Forced full-body shower units installed between contaminated and semi-contaminated zones, where personnel and garments are decontaminated with a dosed disinfectant spray before leaving the controlled area.

Cleanroom equipment

Terminal HEPA filter housings for cleanroom ceiling grids, in top-adjustable, replaceable-media and disposable integrated versions; the housing, filter class and ceiling interface are fixed per configuration, and duct connection is done by the installer.

Biopharma and laboratory equipment

Site furniture and fittings in 304 or 316 stainless steel for pharmaceutical plants and laboratories: work tables, trolleys, racks, sinks, wardrobes and shoe cabinets, made to the dimensions of the room.

Cleanroom equipment

Standard HEPA supply outlets (terminal filter boxes with plenum and diffuser plate) for class 1000 to 100000 air-conditioning systems, sized by box, filter face, airflow and duct flange; installed in the ceiling by the buyer's contractor.

Cleanroom equipment

Fresh-air and exhaust filter cabinets for ventilation and make-up air: fresh-air cabinets, medium-efficiency exhaust boxes, activated-carbon adsorption boxes and multi-stage air filter boxes, sized by airflow and filter combination; connected to ductwork by the installer.

Cleanroom equipment

Fan-powered chemical filtration units with a sealed plenum and slide-out filter modules, configured per project with primary, medium, HEPA, activated-carbon or chemical filter stages; duct connection and commissioning are done by the installer.

Cleanroom equipment

Automatic roll-type air filters for pre-filtration of ventilation and air-conditioning intakes, in standard, self-cleaning, explosion-proof and duct-type versions; the roll of media advances automatically on pressure-difference signal, and the frame size is fixed per configuration.

Cleanroom equipment

Open horizontal laminar flow clean benches that wash the work zone with filtered air flowing from the rear towards the operator, for processes harmless to the operator; specified by work zone size and placed by the buyer.

Medical and hospital equipment

Ceiling-mounted laminar supply units for operating theatres, delivering HEPA-filtered air at a steady face velocity over the operating zone, sized by theatre type and ceiling opening.

Medical and hospital equipment

Supply ceilings for clean operating theatres with a leak-protection layer below the filter bank, factory-made modules assembled on site, and filter replacement from above the ceiling without entering the protected room.

Medical and hospital equipment

Terminal HEPA supply outlets with a mesh diffuser face for cleanrooms, combining plenum box, final filter and diffuser in one unit for new builds and retrofits.

Medical and hospital equipment

Medium- and high-efficiency terminal grilles for cleanroom return and exhaust duct connections, sized and filtered per the room cleanliness class.

Medical and hospital equipment

Low-initial-resistance medium/high-efficiency filter units for fan-coil and air-handling applications in healthcare rooms, in casing sizes from 400 to 1600 m3/h.

Medical and hospital equipment

Electrostatic air filtration units in five mountings — insert cell, duct section, air-handling-unit section, diffuser outlet and standalone — with washable collection cells.

Medical and hospital equipment

Wall-mounted transfer chambers with interlocked doors and a UV germicidal lamp, for moving sterile items between hospital rooms of different cleanliness class.

Medical and hospital equipment

Electro-galvanised steel (electrolytic sheet) wall panels for operating theatres and cleanrooms, factory cut and folded, assembled on site with services routed in the wall cavity.

Medical and hospital equipment

Stainless steel furniture and fittings for operating theatres and ancillary rooms — cabinets, sinks, workstations, fume cupboards and electrical/gas boxes — made to order against the room layout.